Preparing The Tractor; Hitching To The Tractor - Tatu Marchesan RC2 1300 Instruction Manual

PREP PREP ARA PREP
PREP PREP
If necessary use counterweights on the front of the tractor.
When coupling, find the most level piece of ground possible.
With the tractor in reverse, slowly approach contact with the cutter and be
prepared to apply the brakes. When close, use the lever to control the position of
the hydraulic, so that the lower left arm is at the same heigth as the coupling pin on
the cutter.
1 st ) Couple the lower left arm and insert the lock pin.
2 nd ) Couple the upper arm (3
3 rd ) Finally couple the lower right arm which can be raised or lowered by using
the levelling crank. At this point the extension screw of the upper arm of the tractor
can be used to move the cutter closer or further, to facilitate hitching.
For perfect coupling, the cutter should be centralised with the tractor, and this
is done in the following manner:
- Align the drawbar of the cutter with the third point of the tractor.
- Lift the cutter completely
- Check that the distances between the lower arms and the tyres are equal on
both sides (measurement "A" in the figure below), both beig at the same height.
Note: - NEVER ADJUST THE LOWER ARMS OF THE HYDRAULIC WITH THE CUTTER
LOWERED.
ARA ARA TION FOR USE ARA TION FOR USE TION FOR USE TION FOR USE
ARA TION FOR USE

Preparing the Tractor

Hitching to the Tractor

rd point) and insert the lock pin.
A
11
A