As-I Module Installation - Siemens MICROMASTER 411 Operating Instructions Manual

Issue 01/03
6. Remove any sharp edges/burrs/swarf in the knockouts and terminal housing.
7. Slide the fixing plates into the slots provided immediately behind the gland
access holes (as shown in Figure 2-4).
8. Ensure that the earth lead is fed back through the fixing plate.
9. Feed the earth lead into the AS-i Module housing and connect it at the fixing
plate.
10. Replace the Filter Module.
2.2

AS-i Module Installation

With the fixing plates
inserted it is now
possible to mount the
AS-i Module by
carrying out the
following procedure:
1. Unscrew the four
M4x10 cover
retaining screws
(see Figure 2-5).
2. Carefully detach the
module cover
from the base
3. Insert the "O" ring
sealing gaskets
(see Figure 2-6).
Gaskets should be
placed in position
adhesive-side to the
inverter.
4. Detach internal
cables between
option cover and
base.
5. Align the Options
case with the
Fixing plates (See
Figure 2-6).
6. Fasten the
Options module
base to the fixing
plates using the
M4x20 retaining
screws
Figure 2-5 above).
7. Using the U-clamp
and M4x10 screw,
connect the earth
lead (attached to
the fixing plate) to the earth stud (shown as
module housing.
MICROMASTER 411 & COMBIMASTER 411, AS-i Module Operating Instructions
6SE6400-5AT00-0BP0
.
Figure 2-5
(see
Figure 2-6
Installing the AS-i Module
AS-i Module Layout
AS-i Module Fixing to Inverter
in Figure 2-6 above) within the
13