Force Led - Allen-Bradley Logix 5000 Programming Manual

Force steps

Force LED

Forces tab status
Enabled
Disabled
Installed
None Installed
If your controller has a FORCE LED, use the LED to determine the status of any
I/O forces.
Important: The FORCE LED shows only the status of I/O forces. It does not show the status of SFC forces.
If the FORCE LED is:
Off
Flashing
Solid
Rockwell Automation Publication 1756-PM006I-EN-P - February 2018
Means
• If the project contains any forces of this type, they are overriding your logic.
• If you add a force of this type, the new force immediately takes effect
Forces of this type are inactive. If the project contains any forces of this type, they are
not overriding your logic.
At least one force of this type exists in the project.
No forces of this type exist in the project.
Then:
• No tags contain force values.
• I/O forces are inactive (disabled).
• At least one tag contains a force value.
• I/O forces are inactive (disabled).
• I/O forces are active (enabled).
• Force values may or may not exist.
Chapter 3
81