Important Installation Guidelines - Empire Comfort Systems VFPC20in33N-1 Installation Instructions And Owner's Manual

Vent-free fireplace insert
Hide thumbs Also See for VFPC20in33N-1:
Table of Contents

Advertisement

SAFETY INFORMATION FOR USERS OF PROPANE Gas (ConT'D)
If, at any time, you do not smell the Propane Gas odorant and
you think you should, assume you have a leak. Then take the
same immediate action recommended above for the occasion
when you do detect the odorized Propane Gas.
If you experience a complete "gas out," (the container is under
no vapor pressure), turn the tank valve off immediately. If the
container valve is left on, the container may draw in some air
through openings such as pilot light orifices. If this occurs, some
new internal rusting could occur.

IMPORTANT INSTALLATION GUIDELINES

PROPER LOG PLACEMENT
Log placement is critical to proper burner performance. Logs must
be correctly positioned onto the burner. The photos in this manual
show the proper pinned position for logs on this set. Owners need to
be shown proper log placement and instructed not to move the logs.
Logs must fit firmly onto the burner when positioned as shown in
the photos. Malformed logs or logs with sloppy pin holes must be
replaced.
ProPer PLaCeMenT oF roCK WooL anD
DeCoraTIve Lava roCK
Rock wool can be added to burners for a glowing ember effect.
It must be positioned only on the front portion of the burner. The
photos in this manual show the proper placement of rock wool.
Decorative lava rock or small wood pieces should never be placed
on the burner. These items are only for placement on the floor of
the fireplace or firebox.
PROPER PRIMARY AIRFLOW INTO BURNER
For proper burner operation and flame appearance, the flow of
primary air into the venturi tube, located on the rear of the burner,
must not be reduced. This flow of air is reduced if dirt, lint or other
obstructions build-up around or inside the venturi. Any obstruction
in the venturi tube area must be removed. The flow of air into the
venturi is also reduced if the gas orifice isn't centered in the venturi
inlet and/or is not aligned with the venturi. Any misalignment of the
burner orifice may be corrected by bending the shutter cap holding
the orifice to the inlet of the venturi tube.
CEILING FANS, PORTABLE FANS OR LOGS
INSTALLED NEAR COLD AIR RETURNS
Ceiling fans or oscillating floor type fans need to be monitored
during the operation of vent-free logs. If the air blows directly
into the flame causing it to impinge on the log set, or firebox, it
should be turned off or redirected. Ceiling fans could be reversed
to possibly eliminate flame impingement, and the floor fan could
be redirected. Upon installation, be aware of any cold air returns
or vents in the proximity of the log set. Any draft created around
a vent-free log set can cause the flame to impinge on the log and
create a sooting situation.
39236-1-0219
If the valve is left open, then treat the container as a new tank.
Always be sure your container is under vapor pressure by
turning it off at the container before it goes completely empty
or having it refilled before it is completely empty.
Do not allow fans to blow directly into the fireplace. avoid
any drafts that alter burner flame patterns.
Do not use a blower insert, heat exchanger insert or other
accessory not approved for use with this heater.
CANDLES
Avoid the use of scented or decorative candles while the log set is
in operation. Candles produce a residue in the air that creates a
soot like substance. Burning candles while the log set is operating
magnifies the problem. It should be noted that candles, in general,
produce soot. The amount of time burned and the quantity of
candles burned will determine the amount of soot produced and
deposited.
MaKe oWners aWare oF ProPer LoG seT oPeraTIon
Properly installed and properly maintained log sets do not deposit
soot on the logs. If users see soot appear on a log, call for service.
Do not continue to operate the log set.
This appliance is only for use with the type of gas indicated on
the rating plate and may be installed in an aftermarket, perma-
nently located, manufactured (mobile) home where not prohib-
ited by local codes. This appliance is not convertible for use with
other gases.
Do not operate the appliance with panel(s) removed,
cracked or broken. replacement of the panel(s) should be
done by a licensed or qualified service person.
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, personal injury
or loss of life. Installation and service must be performed
by a qualified installer, service agency or the gas supplier.
WARNING
WARNING
CAUTION
WARNING
Page 7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents