ring SmartCharge RSC701 Instructions Manual page 3

How to Charge Your Battery
1. With the charger unplugged from the mains, connect the
clips to the battery as detailed below
For batteries inside the vehicle
- Attach the red (+) battery clip to the red (+)
terminal on the battery
- Attach the black (-) battery clip to a bolt or bracket on the
engine block, away from the battery and fuel lines
For batteries outside the vehicle
- Attach the red (+) battery clip to the red (+)
terminal on the battery
- Attach the black (-) battery clip to the black (-)
terminal on the battery
Smart Maintenance Battery Charger
Features
1
2
Charge Status Led
Green Flashing = Green Solid =
Charging Fully Charged
If the battery charger shows as solid red, the clips have
connected to the wrong terminals and need to be
swapped over.
2. For the smart charger plus select the "start/stop" setting if
3. With a correct connection a solid green light will show.
4. To select a different charging mode, press the charging
Smart Battery Charger with Protection
Features
1 Hook
1
2 Auto 6V/12V
detection
2
3
4
5
6
Charge Status Led
Green Flashing =
Red Solid=
Charging
Polarity Check
(Incorrect Battery Connection)
your vehicle uses this technology.
Plug the battery charger into the mains and the charger
will automatically select the best program to use.
mode button until the desired mode is selected.
Green Solid =
Fully Charged
1 Hook
2 Normal
Charge
3 Maintenance
Charge
4 12V LED
5 Charging
Mode
Lith
6 Charge
Status LED
Maintenance Charge Lithium
Normal Charge
Lithium
Red Solid=
Polarity Check
(Incorrect Battery Connection)