Download Print this page

Specifications; Limited Warranty; Troubleshooting - John Bunn JB02017 Operator's Manual

Oxyread fingertip pulse oximeter

Advertisement

SPECIFICATIONS

Display Type
LED (Light Emitting Diode)
SpO
Measurement
2
range
Accuracy
Pulse Rate
Measurement
range
Accuracy
Pulse Intensity
Power Requirement
Two AAA alkaline Batteries
Power Consumption <40 mA
Low Power Indicator
Battery Life
~ 30 hours of continuous operation
Dimension
2.20" ~ 2.44" x 1.26" ~ 1.50" x 1.34" ~ 1.50"
(L x W x H)
(56 mm ~ 62 mm x 32 mm ~ 38 mm x 34 mm ~ 38 mm)
Weight
1.59 oz ~ 2.12 oz (0.10 lb ~ 0.13 lb) (45 g ~ 60 g)
including two AAA batteries
Environmental
Temperature
Requirements
Humidity
(non-condensing)
Interference
Device works normally when mixed noise produced
Resistance Capacity
by BIO-TEK INDEX Pulse Oximeter tester
against Ambient Light
DECLARATION
This product's EMC complies with IEC60601-1-2 standard.
The materials with which the user can come into contact have
no toxicity, no action on tissues, and comply with ISO10993-1,
ISO10993-5 and ISO10993-10.
GUIDANCE AND MANUFACTURER'S DECLARATION:
ELECTROMAGNETIC EMISSIONS FOR ALL EQUIPMENT
AND SYSTEMS
Guidance and manufacturer's declaration – electromagnetic emission
The Pulse Oximeter is intended for use in the electromagnetic
environment specified below. The customer or the user of the Pulse
Oximeter should assure that it is used in such an environment.
Emission Test Compliance Electromagnetic environment – guidance
RF emission
Group 1
The Pulse Oximeter uses RF energy only for its
internal function. Therefore, its RF emissions
CISPR 11
are very low and are not likely to cause any
interference in nearby electronic equipment.
RF emission
Class B
The Pulse Oximeter is suitable for use
in all establishments, including domestic
CISPR 11
establishments and those directly connected to
the public low-voltage power supply network that
supplies buildings used for domestic purposes.

TROUBLESHOOTING

Problem
Possible reason
1. User's finger is incorrectly
SpO
or PR
2
inserted
cannot be
2. User's Oxyhemoglobin
displayed
value is too low to be
normally
measured
1. Finger may not be
SpO
or PR
2
inserted deeply enough
display is
2. Finger trembling or user
unstable
moving
70-99%
80%-99%: ±2%
70%-79%: ±3%
≤69% : no definition
30-235 BPM
30~99 BPM: ±2 BPM
100~235 BPM: ±2%
Bargraph Indicator
Operation
41°F ~ 104°F
(5°C ~ 40°C)
Storage
-13°F ~ 158°F
(-25°C ~ 70°C)
Operation
≤80% RH
Storage
≤93% RH
Solution
1. Reinsert user's finger
2. Attempt several times to
obtain a reading; If sure that
no problem exists, obtain
further clinical examination
1. Reinsert finger
2. Ask user to remain still
Troubleshooting continued
Problem
Possible reason
1. Battery power may be
Oximeter
inadequate or batteries
cannot be
may not be installed
powered on
2. Batteries may be installed
incorrectly
3. Oximeter may be damaged
1. Device automatically
Indicator
powers off when no signal
lamps are
is detected for longer than
suddenly
8 seconds
off
2. Batteries too weak to
power device
1. Low power
"Error3" or
2. Receiving tube and/or
"Error4"
connector may be
displays
shielded or damaged
3. Mechanical misplace for
receive-emission tube
4. Amp circuit malfunction
1. Low power
"Error7"
2. Emission diode damaged
displays
3. Current control circuit
malfunction
SYMBOL DEFINITIONS
Symbol
Definition
Type BF applied part
Follow instructions for use
﹪ SpO
Oxygen saturation
2
Heart rate (BPM)
BPM
Info: The illustration used in this manual may differ slightly
from the appearance of the actual product.

LIMITED WARRANTY

SCOPE OF WARRANTY
GF Health Products, Inc. ("GF") warrants to the Original Purchaser only that it will replace or repair components, at GF's sole discretion, that are defective
in material or workmanship under normal use and service. All warranties are conditioned upon the proper use of the products strictly in accordance
with good commercial practice and applicable GF instructions and manuals, including p roper use and maintenance. To the extent that a component is
warranted by a third party, GF conveys all of its rights under that warranty to the original purchaser, to the extent permitted. Original Purchaser is one who
purchases this product new and unused from GF or a GF Distributor.
This limited warranty shall only apply to defects that are reported within the applicable warranty period and which, upon examination by GF or its
authorized representative, prove to be a warranty item. This limited warranty is not transferable.Within the guidelines set forth in this document, this
product is warranted for one (1) year. The applicable warranty period shall commence from date of shipment to the Original Purchaser, unless there is an
expiration date on the component in which case the warranty shall expire on the earlier of warranty period or the expiration date.
OBTAINING WARRANTY SERVICE
This limited warranty shall only apply to defects that are reported to the Distributor from whom the Customer purchased the product within the applicable
warranty period. If there is not a Distributor, you must contact GF directly by calling 1-770-368-4700, sending a fax request to 1-770-368-2386, or by
e-mailing a request to cs@grahamfield.com. Specific directions will be provided by the Customer Service Representative. Failure to abide by the specific
directions will result in denial of the warranty claim.
EXCLUSIONS
The warranty does not cover and GF shall not be liable for the following:
1) Defects, damage, or other conditions caused, in whole or in part, by misuse, abuse, negligence, alteration, accident, freight damage, tampering or
failure to seek and obtain repair or replacement in a timely manner;
2) Products which are not installed, used, or properly cleaned and maintained as required in the official manual for the applicable product;
3) Products considered to be of a non-durable nature including, but not limited to: casters, filters, fuses, gaskets, lubricants, and charts;
4) Accessories or parts not provided by GF;
5) Charges by anyone for adjustments, repairs, replacement parts, installation or other work performed upon or in connection with such products which
are not expressly authorized in writing, in advance, by GF;
6) Any labor or shipping charges incurred in the replacement part installation or repair;
7) Costs and expenses of regular maintenance and cleaning; and
8) Representations and warranties made by any person or entity other than GF.
ENTIRE WARRANTY, EXCLUSIVE REMEDY AND CONSEQUENTIAL DAMAGES DISCLAIMER
THIS WARRANTY IS GF'S ONLY WARRANTY AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. GF MAKES NO IMPLIED
WARRANTIES OF ANY KIND INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
IF ANY MODEL OR SAMPLE WAS SHOWN TO THE CUSTOMER, SUCH MODEL OR SAMPLE WAS USED MERELY TO ILLUSTRATE THE GENERAL
TYPE AND QUALITY OF THE PRODUCT AND NOT TO REPRESENT THAT THE PRODUCT WOULD NECESSARILY CONFORM TO THE MODEL OR
SAMPLE IN ALL RESPECTS.
THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT OF THE DEFECTIVE PARTS. GF SHALL NOT BE LIABLE FOR AND HEREBY
DISCLAIMS ANY DIRECT, SPECIAL, INDIRECT, INCIDENTAL, EXEMPLARY OR CONSEQUENTIAL DAMAGES, INCLUDING, BUT NOT LIMITED
TO: DAMAGES FOR LOSS OF PROFITS OR INCOME, LOSS OF USE, DOWNTIME, COVER, OR EMPLOYEE OR INDEPENDENT CONTRACTOR
WAGES, PAYMENTS AND BENEFITS.
The warranties contained herein contain all the representations and warranties with respect to the subject matter of this document, and supersede all prior
negotiations, agreements and understandings with respect thereto. The recipient of this document hereby acknowledges and represents that it has not
relied on any representation, assertion, guarantee, warranty, collateral contract or other assurance, except those set out in this document. Some states do
not allow the exclusion of certain remedies; in those instances that state's law will control. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
For additional information on this product or this warranty, please contact a GF Customer Service Representative.
NOTES:
1) Additional terms and conditions may apply.
2) Freight claims must be notated on the appropriate shipping documents and must be made with immediacy. International, federal and state regulations
govern specific requirements for freight claims. Failure to abide by those regulations may result in a denial of the freight claim. GF will assist you in filing
the freight claim.
3) Claims for any short shipment must be made within three (3) days of the invoice date.
Information contained herein is subject to change.
The most current and complete product information can be found on our website.
© 2012, GF Health Products, Inc. All Rights Reserved.
Graham-Field and John Bunn are trademarks of GF Health Products, Inc.
GF Health Products, Inc. is an ISO 13485 Certified Company.
Manufactured for GF Health Products, Inc.
2
Solution
1. Replace batteries
2. Reinstall batteries
3. Contact GF distributor
1. Normal
2. Replace the batteries
1. Replace batteries
2. Contact GF distributor
3. Contact GF distributor
4. Contact GF distributor
1. Replace batteries
2. Contact GF distributor
3. Contact GF distributor
Symbol
Definition
Low power indicator
No SpO
Power switch
SN
Serial Number
Manufacturer
1.770.368.4700
www.grahamfield.com
Made in China
JB02017-INS-LAB-RevD16
Alarm
2

Advertisement

loading