Power Up The Kvm - Cisco UCS C200 Setup

Power Up the KVM

Complete these steps in order to power up the server:
1. Plug the power cord into the chassis.
Note:
♦
CIMC initializes system standby (Power Off mode).
♦
CIMC is active and can be controlled through GUI or CLI, if you know the IP address.
2. Depress Front Panel Power:
♦
The Fans begins to spin up.
♦
Then POST sequence begins.
♦
At this point you can either boot up or begin the installation process.
♦
Note that for large memory, models can display a blank screen for several minutes.
♦
For C−250If you immediately depress the power switch, you interrupt the CIMC
initialization.