Cisco X2-10GB-SR Installation Notes page 14

Installing the 10-Gigabit Ethernet X2 Transceiver Module
Figure 2
Press firmly on the front of the X2 transceiver module with your thumb to fully seat the transceiver in
Step 6
the transceiver socket. (See
Figure 3
Verify that the X2 transceiver is properly seated and latched in the socket, by grasping the left and right
Step 7
sides (or the top and bottom) of the transceiver's EMI gasket flange with your thumb and forefinger and
gently pulling on the transceiver. Do not pull on the latching sleeve as you will release the transceiver.
If the transceiver does not pull free, it is properly seated and latched.
If the transceiver does pull free, slide the X2 transceiver back into the socket and apply more pressure
with your thumb on the front of the transceiver. Repeat the process until the X2 transceiver is securely
latched in the socket.
Step 8 Reinstall the dust plug into the transceiver's optical bore until you are ready to attach the network
interface cable.
Cisco 10-Gigabit Ethernet X2 Transceiver Modules Installation Note
14
Installing the 10-Gigabit Ethernet X2 Transceiver Module
1
L I N
K
A C
Figure 3.)
Latching the X2 Transceiver Module
2
T I
V E
L I N
K
A C
T I
V E
OL-23589-01