Table of Contents
Advertisement
MITRE FENCE ADJUSTMENT
1. Check the mitre fence is
perpendicular to the disc and
adjust if required.
2. Set the pointer on the mitre fence
to 0° if required
• Once the pointer is set, you can
adjust the angle to whatever
angle you need.
BELT TABLE ADJUSTMENT
1. Loosen the handle.
2. Put an engineers square on the
table touching the belt
3. Adjust the table until it is at right
angles to the belt.
4. Tighten the handle.
5. For fine adjustments, adjust the
grub screw located at the rear of
the table. When correct, clamp
the grub screw in position using
the nut beneath the table.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
8
Advertisement
Table of Contents
