Summary of Contents for Bellman & Symfon Visit BE1282
Page 1
Bellman Visit Smoke Alarm Transmitter Board Model BE1282 Bellman Visit 433,92 MHz FCC approvals FCC ID:WMSBETX1 IC:6693A-BETX1 Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Mode d’emploi de l’Emetteur Alarme incendie Bellman Visit L’Emetteur Alarme incendie Bellman Visit fait partie du système Visit. L’Emetteur Alarme incendie, déclenché par la présence de fumée ou d’un incendie transmet un signal aux récepteurs Bellman Visit. Procédez de la manière suivante ! 1.
Localisation Veuillez consulter le manuel d’utilisateur de Garvan pour plus d’informations. Installation Détachez la plaque de fixation: pressez la languette de verrouillage à l’aide d’un tournevis et poussez l’Émetteur Alarme incendie dans le sens opposé. Insérez la pile. Appuyez sur le bouton de test pendant quelques secondes jusqu’à...
Test et entretien Vérifiez le fonctionnement de l’émetteur d’alarme au moins une fois par mois, de préférence une fois par semaine. Testez toujours après une absence prolongée, par exemple après des vacances. L’émetteur peut être testé en appuyant sur le bouton test pendant cinq secondes ou en souf- flant de la fumée vers l’émetteur d’alarme.
Page 5
Comment éviter un incendie Ne laissez pas d’allumettes à la portée des enfants. Veillez à éteindre les bougies quand vous quittez la maison. Ne videz jamais de cendriers dans une corbeille à papier. Mettez de l’eau dans le cendrier avant de le vider. Avant d’aller vous coucher, vérifiez que le feu de cheminée est éteint ou que le part-feu est mis.
Instructions for Bellman Visit Smoke Alarm Transmitter Unit Bellman Visit Smoke Alarm Transmitter Unit is part of the Visit System. Bellman Visit Smoke Alarm Transmitter Unit transmitts signals to Bellman Visit Receivers when activated by the smoke alarm. This is what to do! 1.
Page 7
Location Please read further in the Garvan Smoke Alarm instruction manual. Installation Loosen the mounting bracket by pressing the lock with a screwdriver and pushing the Smoke Alarm in the opposite direction. Connect the battery. Press the test button for a few seconds until the alarm sounds and the Bellman Visit receiver responds.
Testing and maintenance Test your Smoke Alarm Transmitter Unit at least once a month, preferably every week. Always make a test when returning from vacation or any longer absence. You can test your Smoke Alarm Transmitter Unit either by pressing the test button for five seconds, or by blowing smoke towards the alarm.
Page 9
To avoid fire See to that matches are kept out of children’s reach. Never leave lighted candles unattended. Never empty ashtrays into a wastepaper basket or a rubbish bag without knowing that every- thing is properly extinguished. Pour water into the ashtray before you empty it or let it stand overnight. Before you go to bed, see that the fire in the fireplace is properly extinguished or that the fire screen is in place so that no sparks can fly out.
Need help?
Do you have a question about the Visit BE1282 and is the answer not in the manual?
Questions and answers