Decatur Electronics GHD User Manual page 11

Menu Settings (
DIRECTION (dir): Direction lets you select the direction of the
vehicle you want to display The dir default value t A indicates that
you are monitoring vehicles moving both toward and away from the
radar gun
BACKLIGHT (bL): This turns on and of the LCD backlight bL ON is
the default setting
AUDIO (Aud): The Audio setting controls the volume level of the
Doppler tone The volume level settings are from 4 to 8 (4 is lowest,
and 8 is the highest volume level )
20
Figure 5.1b
International Version Only)
1
25/Aug/2010
SENSITIVITY LEVEL (SEn): The SEn option lets you control the
maximum target-acquisition range SEn levels range from 1 through
6 (1 is the minimum range, and 6 is the maximum range )
SQUELCH (SLh): The squelch determines the type of Doppler audio
you want the radar gun to send out When squelch is on, the sound
is only the Doppler tone for the displayed target When squelch is of,
you will hear all Doppler tones, including other vehicles, interference
and any noise the antenna receives
COMMUNICATIONS PORT (Prt): The Prt setting indicates which
communication port confguration you want the system to use Zero
means no serial communication, and 1 through 6 (and 7 if you have
the international version) are various setting options (see the menu
settings )
FASTER VEHICLE (FSt): The FSt setting programs the FAST button
for either Faster-Hold or Faster-Toggle mode The default, 1, is Faster-
Toggle, and 0 is Faster-Hold
MINI-TEST (tSt): The tSt requires the system to automatically
perform a "mini" self test every 10 minutes
BEEP (bEP): The bEP option sets the system to give an audible "beep"
to verify every time a key is pressed bEP ON is the default setting
POWER DOWN (Prd): The Prd option (Scout only) and is designed
to maximize the amount of time the radar can operate before the
batteries need to be recharged With the feature set to ON the radar
will automatically power of if there has not been any trigger or key
presses for 15 minutes in order to conserve battery power Prd ON is
the default setting
25/Aug/2010
21