Miele K 31222 Ui Operating And Installation Instructions page 36

Table of Contents

Advertisement

Problem solving guide
Problem
The compressor is
switching on more
frequently and runs for
longer periods of time,
and the temperature in
the appliance is too low.
The compressor comes
on less and less often
and for shorter periods
of time. The
temperature in the
appliance rises.
An alarm is sounding.
The door seal is
damaged and needs to
be replaced.
36
Possible cause and remedy
The ventilation gaps are covered or have become too
dusty.
 Do not block the ventilation gaps.
 Clean the dust from the ventilation gaps on a
regular basis.
The door has been opened too frequently, or a large
amount of fresh food has been placed inside the
appliance.
 Only open the door when necessary and for as
short a time as possible.
After a while the temperature will return to normal by
itself.
The ambient room temperature is too high. The higher
the room temperature, the longer the compressor will
run.
 See the information in "Installation – Location".
The temperature setting is too low.
 Correct the temperature setting.
The SuperCool function is still switched on.
 To save energy, you can switch SuperCool off
early yourself.
This is not a fault. The temperature is too high.
 Correct the temperature setting.
 Check the temperature again after 24 hours.
The door alarm has been activated (see also "Door
alarm").
 Close the appliance door.
The alarm will stop.
No tools are required to change the door seal.
 Change the door seal. A replacement is available
from Miele.

Advertisement

Table of Contents
loading

Table of Contents