GBC Ultima 65 Installation & Operation Manual page 3

1. Safety
YOUR SAFETY, AS WELL AS THE SAFETY OF OTHERS IS
IMPORTANT TO GBC. IN THIS INSTRUCTION
MANUAL AND ON THE PRODUCT ARE IMPORTANT
SAFETY MESSAGES. BEFORE YOU INSTALL OR USE
THE MACHINE, READ AND FOLLOW ALL THE SAFETY
NOTICES CAREFULLY IN THIS CHAPTER
Observe all the safety information provided.
Observe all safety warnings. Never remove safety
warnings or other information from the equipment.
Read all of the instructions and save these
instructions for further use.
The safety alert symbol precedes each safety
notice in this manual. The symbol indicates a
potential personal safety hazard to you or others, as
well as cause product damage or property damage.
This safety alert symbol indicates a potential
electrical shock. It warns you not to open the paper
cutter and expose yourself to hazardous voltage.
THE FOLLOWING WARNINGS ARE FOUND ON THE
ULTIMA 65 LAMINATOR.
This means you can be seariously hurt or killed if you
open the product and expose yourself to hazardous
voltage.
Do not open. No user servicable parts insides. Refer
servicing to qualitfied service personal.
This safety message means that you could be burned
and your fingers or hands could be trapped and
crushed in the hot rollers. Clothing, jewelry long hair
.
could be caught in the rollers and pull you into
them.
This safety notice means you can cut yourself if
not careful operating the trimmer.
WARNING: Do not attempt to service or
repair the laminator.
WARNING: do not connect the laminator
to an electrical supply or attempt to operate the
laminator until you have completely read these
instructions. Maintain these instructions in a
convenient location for future reference.
General safeguards
• Use this laminator only for its intended
purposes as according to the
specifications outlined in the operating
instructions.
• Keep hands, long hair, loose clothing and
articles such as necklaces or ties away
from the front of the rollers to avoid
entanglement and entrapment.
• Avoid contact with the rollers during
operation or shortly after the laminator
has been turned off. The rollers can
reach temperatures in excess of 300ºF.
• Keep hands and fingers away from the
path of the sharp film cutter blade
located at the film exit.

Do not place the laminator on an
unstable cart, stand or table. An
unstable surface may cause the
laminator to fall resulting in serious
bodily injury. Avoid quick stops,
excessive force and uneven floor
surfaces when moving the laminator on
a cart or stand.
• Do not defeat or remove electrical and
mechanical safety equipment such as
interlocks, shields and guards.