GBC Ultima 65 Installation & Operation Manual page 10

Figure 5
E. FEED TABLE LATCHES: (figure 5) Used to unlock and
lock the FEED TABLE.
F. FEED TABLE GUIDE: (figure 5) Aligns items as they
are being fed into the laminator. Especially helpful
on longer items to reduce skew. The guide can be
moved by loosening the knob and sliding the guide
to the desired position and then tightening the
knob.
Figure 6
G. HEATED NIP ROLLERS: (figure 6) Heats the film to
activate the adhesive and provides pressure to
ensure film adheres to the media.
.
H. IDLER BARS: (figure 6) The Idler Bars, located near
each supply roll, are used to direct the film to the
NIP ROLLERS. The lower Idler Bar is attached to the
Feed Table to facilitate easy film loading.
I. PULL ROLLERS: The Pull Rollers are located at the
back of the laminator. They simultaneously pull the
film through the laminator and provide tension as
the film cools to ensure quality lamination.
Figure 7
J. REAR SLITTER: (figure 7) Used to cut the film when
it exits the rear of the laminator.
K. FUSE: (figure 2) The Fuse is an electrical safety
device, located under the main power switch.
L. AUTO SHUT-OFF: After two hours of inactivity the
laminator will shut down. To activate the laminator,
ensure the Main Power button is in the ON position
('I ') and press the ON/OFF button on the front of
the machine.
Figure 8
M. FILM ROLL SUPPLY: The Ultima 65 can use both EZ
Load and Standard roll laminating film (figure 8).
Figure 9
N. FILM SADDLES: Film supply is loaded into the
saddles (figure 9).
O. FILM SHAFT: The Film Shaft is used for loading
standard film onto the Ultima 65 Laminator.
P. FILM SHAFT HOOKS: Located on the back of the
machine the shaft hooks are used to store the Film
Shaft when EZ load film is being used.