Advertisement
Any changes or modifications to the equipment not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Only the following antennas should be used with this limited module and the antenna should only be
installed when the host product is manufactured. (The antenna is not field replaceable.)
• PulseLARSEN W3357 (50Ω impedance; peak gain over 2400 – 2483.5 MHz range is 0.4dBi)
• Walsin RFPCA430618IMAB301 (50Ω impedance; peak gain over 2400 – 2483.5 MHz range is 2.2dBi)
You must follow these codes and safety standards when installing this product:
-National Electric Code (NEC)
-Applicable Federal, Standard and Local Electric Codes
-U.L. safety standards.
Failure to comply with these codes and standards may cause death, serious injury, and property damage.
Before installing this driver:
1. Remove Power from fixture by switching circuit breaker powering the fixture to the off position.
a. Caution: Turning off the fixture's wall switch may not remove voltage from fixture.
2. For maximum safety, fixture must be grounded. Make sure fixture is properly grounded
with a green ground wire per National Electrical Code (NEC).
3. Verify that driver is the correct driver for the fixture, input voltage, and application.
During installation:
1. Follow all relevant National Electric Code (NEC), Federal, State and Local Electric Codes as
well as U.L. safety standards.
2. Access and open driver compartment cover.
3. Remove old driver and any extra wires from enclosure.
4. Inspect and replace any damaged or deteriorated cable.
5. Review the wiring diagram on the new driver label (figure below) and identify connections to be made.
Advertisement
