Advertisement
2.8 Display and delete of single data
After power on for 5 seconds, hold
time, single trip riding time (TM) and single trip distance (DST) flash, hold
button shortly, the content of both is cleared. If failed holding the
button within 5 seconds, it will automatically return the display interface
after 5 seconds, original content is preserved.
3. Display 2
Hold
mode after 5 seconds, display 2 automatically returns to display 1.
4. Display 3
Hold
condition, five seconds later, a single maximum speed (MXS) display
automatically returns to the real riding speed (KM/H).
5.
In display 3, hold
button shortly (SW), and the display will re-enter display 1.
6.
Hold
button to turn off the display and the power supply of controller.
7. Automatically prompt interface
7.1 Error Code Display
Error Code
01＿info
03＿info
04＿info
05＿info
06＿info
Motor or controller has short circuit Abnormality
Electronic control system failure will display (flashing) fault code. Once the fault was removed, it
automatically exits from the fault code display interface.
General Project Setting
1. Set maximum riding speed
After power on for 5 seconds, hold
time, maximum riding speed KM/H and MXS flash, hold
shortly to set the maximum riding speed (default 25KM/H). Hold
shortly and go to the next parameter settings.
and
button shortly in display 1 to enter display 2. In the riding
button shortly in display 2 to enter display 3. In the riding
Definition
Throttle Abnormality
Motor hall signal Abnormality
Torque sensor signal Abnormality
Axis speed sensor Abnormality(only applied to torque sensor)
and
2. Wheel diameter setting
button at the same
shortly and go to the next parameter settings.
3. Set the metric or
4. KM/H and KM stop flash after metric unit setting is completed. Hold
re-enter the maximum riding speed setting interface; or hold
environment of routine projects and save the setting values, returning to display 1.
5. Exit from routine project setting
All three routine project settings can exit from the setting environment and return to the display
if hold
button long after each setting is completed, meanwhile the setting values are saved.
Under each setting interface, if the button failed holding for more than 1 minute, it will
automatically return to display 1, and the setting value is invalid.
Outline Drawings and Dimensions
1. Dimensions of main instrument body
2. Wiring diagram
button at the same
or
button
button
The wheel diameter will be set after finishing setting the maximum
riding speed, wheel diameter specifications flashes. Hold
shortly to set the specifications of wheel diameter. Select the range
6,8,10,12,14,16,18,20,22,24,26,700C,28 and 29 inches. Hold
imperial
units
The metric or
imperial
units will be set after finishing setting wheel
diameter, KM/H and KM flash. Hold
metric or
imperial
units of speed and mileage in synchronization.
Display
Metric
Riding speed
KM/H
Total distance
KM
or
button
button
or
button shortly and select
Imperial
MPH
Mil
button shortly again to
button long to exit from setting
Advertisement
