Sony CCD-TRV338 Camera Operation Manual page 13

6
Slide the POWER switch up to (CHG)
OFF.
The CHG (charge) lamp lights up and
charging starts.
After charging the battery
The CHG (charge) lamp turns off when the
battery is fully charged. Disconnect the AC
Adaptor from the DC IN jack.
To remove the battery pack
BATT (battery)
release button
1
Lift up the viewfinder.
2
Set the POWER switch to (CHG) OFF.
3
Slide the battery pack out in the direction
of the arrow while pressing the BATT
(battery) release button down.
b Note
• If you do not use the battery pack for a long time, use
up the battery pack completely before storing it. See
page 96 about storage of the battery pack.
POWER switch
To check the remaining battery – Battery
Info
DISPLAY/BATT INFO
OPEN
You can check the battery's current charge level
and its current remaining recording time both
during charging or when the power is turned off.
1
Set the POWER switch to (CHG) OFF.
2
Press OPEN and open the LCD panel.
3
Press DISPLAY/BATT INFO.
The battery information appears for about 7
seconds.
Keep the button pressed to view it for about
20 seconds.
BATTERY INFO
BATTERY CHARGE
0% 50%
REC TIME AVAILABLE
LCD SCREEN:
VIEWFINDER: 112 min
A Battery charge level: Displays
approximate remaining amount of
power left in the battery pack.
B Approximate possible recording time
using the LCD panel.
C Approximate possible recording time
using the viewfinder.
Charging time
Approximate number of minutes required when
you fully charge a fully discharged battery pack
POWER switch
LEVEL
100%
81 min
,continued
13
Getting started