Hd White Balance Adjustment - Panasonic TH-37PV7P Service Manual

Hide thumbs Also See for TH-37PV7P:
Table of Contents

Advertisement

TH-37PV7F / TH-37PV7P / TH-37PX7B / TH-37PX7E / TH-42PV7F / TH-42PV7P / TH-42PX7B / TH-42PX7E

12.3. HD white balance adjustment

Instrument Name
· · · · 1080i W/B Pattern
· · · · Color analyzer(Minolta CA-100 or equivalent)
· · · · Asing time is longer than 15min.
· · · · Make sure the front panel to be used on the final set is fitted.
· · · · Make sure a color signal is not being shown before adjustment.
· · · · Put the color analyzer where there is little colour variation.
Complete the adjustment within 10 minutes after the turn on electricity.
Turn on the power supply again when it is not possible to complete it by aging etc.
1. Display the white balance pattern.
2. Enter the service mode.
3. A number key "1" and "2" are operated and "WB-ADJ" is displayed.
Check that the color balance is "HIGH".
4. Select "G-CUTOFF" item, using the number-key "3" or "4", and set to "80", using the volume-
key "+" or "-".
Also, "B-CUTOFF" and "R-CUTOFF" set to "80".
5. Set "G-DRIVE" at "E0".
6. Touch the signal receiver of color analyzer to the highlight window's center, and adjust B
drive and R drive so x, y become the "Color balance Cool" in the below table.
7. All RGB drive increase so that the maximum drive value of RGB may become "FC".
("ALL-DRIVE" set to "FC".)
8. Set color balance to "NORMAL" using "7" key.
9. Fix G cutoff , B cutoff and R cutoff at "80".
10. Fix G drive at "E0".
11. Adjust B drive and R drive so the highlight window's x, y become the "Color balance
"Normal" in the below table.
12. All RGB drive increase so that the maximum drive value of RGB may become "FC".
("ALL-DRIVE" set to "FC".)
13. Set color balance to "LOW".
14. Fix G cutoff, B cutoff and R cutoff to "80".
15. Fix G drive to "E0".
16. Adjust B drive and R drive so the highlight window's x, y become the "Color balance Warm"
shown in the below table.
17. All RGB drive increase so that the maximum drive value of RGB may become "FC".
("ALL-DRIVE" set to "FC".)
Connection
· · · · RF input
· · · · Panel surface
Procedure
32
Remarks
User setting: Normal
Remarks
Picture menu: Dynamic
ASPECT:16:9
· · · · Highlight section
Signal amplitude 75%
* The Color balance COOL differs from
Japanese model values.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents