Advertisement
7.
Carefully lay 2A - Side/Rear Wall Panels face
down. Position and attach 2B - Bottom Wall Plates
to bottom of wall studs of each wall panel with
3 - 2 1/2" Screws. Position so plates are flush with
framing. Complete 4 remaining solid walls.
Important: Make sure all walls are aligned in their
upright position. If not, water may leak into your shed.
Unsure if panel is facing up or down?
Recently attached Bottom Plate is on bottom of panel.
8.
Starting on one side, position a Solid Wall Panel on top of plywood floor. The Wall Panel bottom framing
will sit flush with the outside of the floor frame. Wall siding will overhang the floor.
9.
The rear wall panels will sit even with the floor frame and the sidewall panels will be sandwiched
between the front and rear wall panels. The floor plywood may be slightly recessed.
Note: Siding will overhang the floor frame by approximately 3/4".
Toll Free 1-888-658-1658
You can find BR1 -
Square Drive Bit for
the screws in with the
Hardware Kit Bag.
Bottom Wall Plate
2A - Side/Rear Wall Panels
(45 1/2" wide x 75" high) x 5
2B - Bottom Wall Plates
(1 5/8" x 2 1/2" x 45 1/2") x 5
Do Not Attach Walls
To Floor until Step 23.
Outside 2x3 framing of wall panel should
be positioned flush with the outside of
floor framing when properly aligned.
www.outdoorlivingtoday.com
Page 8
Parts
Floor plywood
may be slightly
recessed
sales@outdoorlivingtoday.com
Ensure bottom plate
is flush side-to-side
with wall studs
Hardware
S1 - 2 1/2" Screws
x 15 total
Siding overhangs
floor frame by 3/4"
Advertisement
