Troubleshooting - Klarstein 10033106 Manual

Charcoal Filter Installation
1. Please remove the interior of your cooker hood by removing the grease filters. These
are located at the bottom of the hood (see illustration above).
2. Inside the hood you will see the motor. This one has an air intake on the left and right
side.
3. Now place the activated carbon filters on the air inlets one after another and lock
them with a clockwise rotation. The filter will snap in and out audibly.
4. Close the interior of the cooker hood by reinserting the grease filters.
The extractor hood is now converted to recirculation mode. There is no special mode or
switch that needs to be activated.
How often should I change the filters?
Changing the filters depends on the frequency of use of the hood. As a general
guideline, they should be changed every 3 months if used regularly.

TROUBLESHOOTING

Fault
Light on, but motor does
not work.
Possible Cause
The leaf blocked.
The capacitor damaged.
The motor jammed
bearing damaged.
The internal with of motor
off or a bad smell from the
motor.
Solution
Get rid of the blocking.
Replace capacitor.
Replace motor.
Replace motor.
EN
17