Press X/x to select the security mode,
• [None]: Select this if the wireless LAN is
unsecured. Setup of wireless LAN
connectivity is finished. Next, enter the IP
address settings by following the Steps of
"Auto setting" or "Manual setting" in
"When connecting to the LAN with a
LAN cable" above.
• [WEP]: The wireless LAN is protected by
a WEP key.
• [WPA/WPA2-PSK]: The wireless LAN is
protected by a WPA-PSK or WPA2-PSK.
• [WPA2-PSK]: The wireless LAN is
protected by a WPA2-PSK.
Enter the WEP key/WPA key by
following the on-screen messages,
then press c.
Setup of wireless LAN connectivity is
finished. Next, enter the IP address settings
by following the Steps of "Auto setting" or
"Manual setting" in "When connecting to
the LAN with a LAN cable" above.
About wireless LAN security
Since communication via the wireless LAN
function is established by radio waves, the
wireless signal may be susceptible to
interception. To protect wireless
communication, this system supports various
security functions. Be sure to correctly
configure the security settings in accordance
with your network environment.
Although you can easily make settings, anyone
can intercept wireless communication or intrude
into your wireless network, even without any
sophisticated tools. Keep in mind that there is a
risk of unauthorized access or interception of
WEP applies security to communications to
prevent outsiders from intercepting
communications or intruding into your wireless
network. WEP is a legacy security technology
that enables older device which do not support
TKIP/AES to be connected.
WPA-PSK (TKIP), WPA2-PSK
TKIP is a security technology developed in
response to the deficiencies of WEP. TKIP
assures a higher security level than WEP.
WPA-PSK (AES), WPA2-PSK (AES)
AES is a security technology that uses an
advanced security method distinct from WEP
AES assures a higher security level than WEP or