D.C.A.C. (Digital Cinema Auto Calibration) can
set the appropriate surround sound
• The system outputs a loud test sound when [Auto
Calibration] starts. You cannot turn the volume
down. Give consideration to children and neighbors.
The home menu appears on the TV screen.
Press C/c to select
Press X/x to select [Audio Settings],
Press X/x to select [Auto Calibration],
The confirmation display for [Auto
Connect the calibration mic to the
A.CAL MIC jack on the rear panel.
Set up the calibration mic at ear level using
a tripod, etc. (not supplied). The front of
each speaker should face the calibration
mic, and there should be no obstruction
between the speakers and the calibration
Press X/x to select [OK].
To cancel, select [Cancel].
[Auto Calibration] starts.
The system adjusts the speaker settings
Be quiet during the measurement.
• Before [Auto Calibration], make sure that the
surround amplifier turns on and you install the
surround amplifier in the appropriate location. If
you install the surround amplifier in an improper
location, such as another room, proper
measurement will not be obtained.
Confirm the conclusions of [Auto
The speakers connected to the unit are listed
as [Yes] on the TV screen.
• If measurement fails, follow the message then
retry [Auto Calibration].
• The measurement for [Subwoofer] is always
[Yes] and [Speaker Settings] returns to the
default setting when you perform [Auto
E C M -A
L M IC
A .C A