H3C S9500 Series Operation Manual page 75
Routing switches mpls l3vpn
Hide thumbs
Also See for S9500 Series:
- Command manual (1842 pages) ,
- Operation manual (1504 pages) ,
- Operating manual (76 pages)
Table of Contents
Advertisement
Operation Manual – MPLS L3VPN
H3C S9500 Series Routing Switches
III. Configuration procedure
Note:
This procedure omits part of the configuration for CE router.
1)
Configure IGP on the service provider's backbone network.
# Configure prov_pe1.
<H3C> system-view
[H3C] sysname prov_pe1
[prov_pe1] interface LoopBack0
[prov_pe1-LoopBack0] ip address 5.5.5.5 255.255.255.255
[prov_pe1-LoopBack0] quit
[prov_pe1] vlan 110
[prov_pe1-vlan110] interface vlan 110
[prov_pe1-Vlan-interface110] ip address 10.1.1.1 255.0.0.0
[prov_pe1-Vlan-interface110] quit
[prov_pe1] ospf
[prov_pe1-ospf] area 0
[prov_pe1-ospf-area-0.0.0.0] network 5.5.5.5 0.0.0.0
[prov_pe1-ospf-area-0.0.0.0] network 10.0.0.0 0.255.255.255
# Configure prov_pe2.
<H3C> system-view
[H3C] sysname prov_pe2
[prov_pe2] interface LoopBack0
[prov_pe2-LoopBack0] ip address 4.4.4.4 255.255.255.255
[prov_pe2-LoopBack0] quit
[prov_pe1] vlan 110
[prov_pe1-vlan110] interface vlan-interface 110
[prov_pe1-Vlan-interface110] ip address 10.1.1.2 255.0.0.0
[prov_pe1-Vlan-interface110] quit
[prov_pe2] ospf
[prov_pe2-ospf] area 0
[prov_pe2-ospf-area-0.0.0.0] network 4.4.4.4 0.0.0.0
[prov_pe2-ospf-area-0.0.0.0] network 10.0.0.0 0.255.255.255
Configure basic MPLS capability and MPLS LDP on the backbone network.
# Configure prov_pe1.
[prov_pe1] mpls lsr-id 5.5.5.5
[prov_pe1] mpls ldp
Chapter 1 MPLS L3VPN Configuration
1-74
Advertisement
Table of Contents
