Advertisement
1
2
3
4
5
Step 1: Using the power drill, remove the top two Phillips
head screws on the pull cord side of the generator. It is
recommended to use a bit extension to help reach deep
set screws.
Step 2: Turn the generator to the muffler side and remove
the 6 Phillips screws holding the muffler grate in place.
Step 3: Turn the generator to the non-pull cord side and
remove the top three Phillips screws. Next, remove the
spark plug access cover on the top of the unit.
Step 4: Turn the generator to the control panel side and
remove the 4 Phillips screws indicated in the image to the
left. Then remove the Phillips screw holding the OFF-
RUN-CHOKE switch in the upper right hand part of the
control panel. Once these screws are removed, pull from
the bottom of the control panel assembly to detach it.
NOTE: Be sure not to remove the 2 screws at the bottom
edge of the control panel.
Step 5: Pull back the rubber fuel collector under the gas
cap and remove the clip with a flathead screwdriver. This
clip secures the side panels together.
Advertisement
