Operating The Ekc 315A - Danfoss EKC 315A Manual

Manual

Operating the EKC 315A

To view or change the thermostat setpoint:
To reset to factory default values:
1) Remove the supply voltage to the EKC 315A
2) While pressing both buttons simultaneously, restore power. Factory settings will have been restored
© Danfoss USCO (HMR_MKS), 04-2008
EKC 315A Industrial Evaporator Controller
To enter change mode
Press both buttons
simultaneously
To raise the setpoint
Press the upper button
To lower the setpoint
Press the lower button
To save the change
Press both buttons
simultaneously
USCO.PD.RD0.A1.22 /521U0092
To change a parameter setting:
To access parameter menu
Press the upper button for 5
seconds, then
Use the upper and lower
buttons to scroll through the
parameter list
To enter change mode for a
parameter you have scrolled to
Press the both buttons
simultaneously
To increase the setting
Press the upper button
To decrease the setting
Press the lower button
To save the new setting and
return to the parameter menu
Press both buttons
simultaneously. You can then
make other parameter changes
or,
The EKC 315A will exit the
parameter menu and return
to its normal display when no
buttons have been pressed for
approximately 18-20 seconds.
.
5