Model Aero Polaris EX Manual page 11

4"
Note that the top fuselage piece is supplied as one piece. Shown above is our method of dividing
and attaching the top. The 4" and 2" pieces are glued on and the 16" center piece is held on with
tabs at each end made from scrap wood or foam. We used a couple magnets (not included) in the
center to help hold it down.
Note the 3 mm foam servo cover. This helps keep the wires from interfering with the servos.
Photo at left shows the prop version mount. Again,
epoxy is recommended for assembling the mounts.
We typically paint the wood black. It's not necessary
but we think it looks nicer!
16"
11
2"