Mounting On A Table; Mounting On A Wall; Using The Kensington Security System - LG MN47 Series Owner's Manual

Mounting on a table

• Image shown may differ from your monitor.
1 Lift and tilt the monitor into its upright position on a table.
- Leave a 10 cm (minimum) space from the wall for proper
ventilation.
10 cm
2 Connect the AC-DC Adapter and Power Cord to a wall outlet.
CAUTION
• Do not place the monitor near or on sources of heat, as this may
result in fire or other damage.
• Please be sure to connect the monitor to the AC-DC power adapter
before connecting the monitor's power plug to a wall power
outlet.

Using the kensington security system

(*This feature may vary depending on models.)
• Image shown may differ from your monitor.
The Kensington security system connector is located at the rear of the
monitor. For more information of installation and using, refer to the
manual provided with the Kensington security system or visit http://
www.kensington.com. Connect the Kensington security system cable
between the monitor and a table.
NOTE
• The Kensington security system is optional. You can obtain
additional accessories from most electronics stores.
10 cm
10 cm
10 cm

Mounting on a wall

For proper ventilation, allow a clearance of 10 cm on each side and
from the wall. Detailed installation instructions are available from
your dealer, see the optional Tilt Wall Mounting Bracket Installation
and Setup Guide.
10 cm
10 cm
10 cm
If you intend to mount the monitor to a wall, attach Wall mounting
interface (optional parts) to the back of the monitor. When you install
the monitor using the wall mounting interface (optional parts),
attach it carefully so it will not drop.
1 If you use screw longer than standard, the monitor might be
damaged internally.
2 If you use improper screw, the product might be damaged and
drop from mounted position. In this case, LG Electronics is not
responsible for it.
20MN47A
21MN47A / 21LF430A
Model
22MN47A / 22LF430A
24MN47A / 24LF430A
Wall Mount
A
(A x B)
B
Standard screw
Number of screws
CAUTION
• Disconnect the power cord first, and then move or install the
monitor. Otherwise electric shock may occur.
• If you install the monitor on a ceiling or slanted wall, it may fall
and result in severe injury. Use an authorized LG wall mount and
contact the local dealer or qualified personnel.
• Do not over tighten the screws as this may cause damage to the
monitor and void your warranty.
• Use the screws and wall mounts that meet the VESA standard. Any
damages or injuries by misuse or using an improper accessory are
not covered by the manufacturer's warranty.
• Screw length from outer surface of back cover should be under
8mm.
10 cm
75 x 75
M4 x L10
4
7