Clean The Pre-Filter And All-In-One Multi-Protection Filter; Defrost - Whirlpool DS201HB Operating Instructions Manual

Clean the pre-filter and
1. When " " & " " & "
Multi-Protection filter.
2. Take off the Filter Cover at back of the machine and pre-filter is stick inside the Filter Cover.
3. Take off the All-in-one Multi-Protection filter and remove the dust on filter by vacuum them
gently.
4. Return the All-in-one Multi-Protection filter
5. Return the pre-filter to the Filter cover and then return the Filter cover to the machine.
6. At this moment, the "
than 8 seconds until both
WARNING
All-in-one M u l t i - P r o t e c t i o n Filter:
Never wash with water. Vacuum the
All-in-one Multi-Protection filter should be
very gently and the filter (especially the
side with Active Carbon) may be
damaged if too much force was applied.

Defrost

1. When the copper pipe temperature sensor to the evaporator surface temperature is less than
0 0
or equal to C, the auto Defrost function will be activated automatically.
2. The " " indicator will light up and the unit will start defrost cycle (the compressor will
perform 24 minutes ON, 8 minutes OFF, no other loading conditions change.), the cycle will
repeat until frost free in dehumidpurifier.
3. When the compressor is running within 24 minutes, but the temperature of the copper pipe
0 0
keep below to C, the compressor will not function.
All-in-one Multi-Protection filter
" light up, it is necessary to clean the pre-filter &
to the machine with the tag side face outward
" & " " still light up, press the "
" " & " " disappear.
Remark:
- All-in-one Multi-Protection filter is applicable to
model DS201HB, DS201HW, DS241HB and DS241HW.
- For All-in-one Multi-Protection filter, it is suggested to
replace a new one every 5 years but it depends on the
environment. The life of All-in-one Multi-Protection filter
will be shorten if the room always occupied with cigarette
smoke or dusty air etc...
- Nano-Silver Ion coating pre-filter and Pre-filter
are washable. Make sure to dry them completely before
replace to the machine.
- Nano-Silver Ion coating pre-filter is a pre-filter with
nano silver coating, which is in silver color. It may
change color (such as black or gray) if wash frequently.
For detail, please refer to P.37
CAUTION
Care and
Maintenance
All-in-one
" key for more
47