Connecting The Power Cord (2) - Pioneer AVH-P7500DVD Installation Manual

Connecting the Units

Connecting the power cord (2)

Note:
Depending on the kind of vehicle, the
function of 3* and 5* may be different.
In this case, be sure to connect 2* to 5*
and 4* to 3*.
1*
3*
5*
C a p ( 1 * )
When not using this terminal,
do not remove the cap.
Yellow (3*)
Back-up
(or accessory)
Red (5*)
Accessory
(or back-up)
ISO connector
Note:
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
The pin position of the ISO connector will differ
depending on the type of vehicle. Connect 6* and
7* when Pin 5 is an antenna control type. In
another type of vehicle, never connect 6* and 7*.
5
2*
4*
Yellow (2*)
To terminal always supplied
with power regardless of
ignition switch position.
Red (4*)
To electric terminal controlled
by ignition switch (12 V DC)
ON/OFF.
Orange/white
To lighting switch terminal.
Black (ground)
To vehicle (metal) body.
Blue/white (6*)
This product
Connect leads of the same
color to each other.
Fuse holder
Fuse resistor
Fuse resistor
Speaker leads
White:
White/black: Front left ≠
Gray:
Gray/black: Front right ≠
Green:
Green/black: Rear left ≠
Violet:
Violet/black: Rear right ≠
Front left +
Front right +
Rear left +
Rear right +