Kids First Coding & Robotics Experiment Manual page 2

IMPORTANT INFORMATION
Safety Information
Warning! Not suitable for children
under 3 years. Choking hazard —
small parts and small ball may be
swallowed or inhaled.
Keep the packaging and instructions
as they contain important
information.
Warning. Do not discharge an object
other than the projectile provided
with this toy.
This product requires the Kids First
Coding & Robotics base kit. Refer
to the safety information on the
packaging and in the instructions for
that kit.
Store the experiment material and
assembled models out of the reach
of small children.
WARNING:
CHOKING HAZARD
parts. Toy contains a small ball. Not
for children under 3 yrs.
ANCHOR PINS AND CONNECTORS
Take a careful look at the different assembly
components. Blue anchor pins, pink shaft
plugs, blue joint pins, and gray long joint pins
all look pretty similar at first glance. When you
assemble the models, it's important to use the
right ones.
CONNECTING
FRAMES AND RODS
Use the anchor pins to
connect frames and rods.
AXLES
The building system contains
axles (also called shafts)
of various lengths. When
assembling the model, always
be sure that you're using the
right one.
PART SEPARATOR TOOL
If any of the building pieces are stuck together
and too hard to separate with your bare hands,
— Small
PULLEYS AND GEARS
If pulleys or gears are mounted too tightly
against other components, they can be hard
to turn. If you leave a gap of about 1 mm
between the gear or pulley and an adjacent
component, it will turn easily.
ASSEMBLY TIPS
use the part separator tool like a crowbar
to pry them apart. Use the narrow end
of the lever to remove the anchor
pins. You can use the
wide end to
pry out shaft
plugs.