Page 2
Following the pre-clean step, fill the Brew Bucket with Star San at a concentration of 1 ounce per gallon at 70-80°F for 30 minutes. Moving forward, for best...
Page 3
Next, feed the thermowell through the 17 mm punch found just below the Ss Brewing Technologies logo on the front of the Brew Bucket. The O-ring should be seated against the interior sidewall of the vessel, as shown. Lastly, thread the locknut onto the fitting from the exterior and tighten.
Need help?
Do you have a question about the The Brew Bucket and is the answer not in the manual?
Questions and answers