Philips Salon Multistylist 8-in-1 User Manual page 10

EnglisH
10
 Release the lever and slide the barrel to the end of the lock. Then
wind the lock round the barrel following the spiral profile. Make
sure that the end of the lock is wound in the required direction.
 Open the clip after 5 to 10 seconds and remove the barrel from
the hair. Let the ringlets cool down before combing, brushing or
finger-combing the hair into its final style.
Crimps
1 Connect the crimping/straightening attachment with crimping
plates to the handle (Fig. ).
 Take a lock of hair (max. 5 to 6 cm wide), open the attachment by
pressing the lever and place the lock between the plates of the
crimping/straightening attachment. Start crimping at the
roots (Fig. 10).
 Keep the plates locked for 5 to 10 seconds.
 Open the attachment by pressing the lever and place a lower
section of the same lock of hair between the plates. Make sure
there is an overlap. Repeat this process until you have reached the
end of the lock.
5 Let the crimps cool down. Do not brush or comb the crimps, as
this would ruin them.
The waves, curls and crimps will disappear if your hair gets wet (for
instance when you wash it). You can also use the straightening plates to
make them disappear.
sleek look
1 Open the crimping/straightening attachment. Remove the plates
one by one by grabbing their cool tips and pulling them out of the
attachment (Fig. 11).
 Turn the plates round and slide them back into the
attachment (Fig. 1).
Make sure that the edges of the plates are inserted properly into the
grooves.