Advertisement
WINTERIZING
If water is allowed to freeze in the system, serious damage
to the plumbing and pump may occur. Failures of this type
will void the warranty. The best guarantee against damage
is to completely drain the wash down system. To properly
drain the system perform the following:
1.
Turn
power to the pump. Close the sea-cock
OFF
valve at the through-hull fitting. All water in the inlet
tubing should be drained.
2.
Remove both inlet/outlet port connections at the
pump and drain the tubing.
3.
Turn the pump
and allow water inside the pump to
ON
be purged. It is recommended that the pump's
inlet/outlet port not be reconnected.
4.
Make a note at both the sea-cock valve and hose
spray nozzle that the "Plumbing is Disconnected".
LIMITED WARRANTY
SHURflo warrants Blaster series pumps to be free from material and workmanship
defects under normal use and service for a period of one year from the date of
purchase. In the absence of proof of purchase the warranty is one year from the
date of manufacture indicated on the motor name plate, not to exceed two years in
any event.
"Pro Blaster" models are warranted for two years from the date of manufacture
as indicated on the motor name plate.
Pumps used in commercial applications are warranted for three months from
date of purchase only (proof required).
The limited warranty will not apply to pumps that were improperly installed,
misapplied, or incompatible with components not manufactured by SHURflo.
Pump failure due to foreign debris is not covered under the terms of this limited
warranty. SHURflo will not warrant any pump that is physically damaged, or
altered outside the SHURflo factory.
Warranty claims may be resolved by an authorized dealer service center, or by a
SHURflo service center. All returns are to be shipped with charges pre-paid.
Package all returns carefully. SHURflo will not be responsible for freight damage
incurred during shipping to a service center.
911-444 Rev. E 10/97
GENERAL SAFETY PRECAUTIONS
•
When the vessel is not in use the main power
switch and sea-cock valves should be
However, if left afloat the bilge pump should still
have power.
•
If fuel vapor is detected never operate the engine
or electrical equipment, until the source is located
and/or properly vented.
•
Electrical connections should be soldered and
insulated to prevent shorts and corrosion. Wiring
should be routed away from areas prone to water
and excess moisture.
•
Be a responsible boater, don't pollute our oceans
and waterways.
SHURflo's obligation under this warranty policy is limited to the repair or
replacement of the pump. Pumps found not defective (under the terms of this
limited warranty) are subject to charges to be paid by the returnee for the testing
and packaging of "tested good" units.
Warranty returns will be shipped on a freight allowed basis. SHURflo reserves
the right to choose the method of transportation.
SHURflo is not responsible nor will it reimburse for labor necessary to remove
and reinstall a pump, if found defective
This warranty is only a representation of the complete Marine Products Limited
Warranty outlined by Service Bulletin
# # # #
ISO Certified Facility
Shipping/UPS: 12650 Westminster Ave.
OPTIONAL FITTINGS
SHURflo supplies taper-seal swivel-barb fittings to
connect to the pumps 1/2" threaded ports to various
.
OFF
tubing sizes .
TUBING
5/8"[15.5
Garden Hose Adapter
Blaster Spray Nozzle
¤ Included with a retail Blaster pump kits
#
SHURflo reserves the right to update specifications, prices, or make substitutions.
SHURflo # # # #
12650 Westminster Ave.
Santa Ana, CA 92706-2100
(800) 854-3218 (714) 554-7709
FAX (714) 554-4721
Garden Grove, CA 92843
ELBOW
STRAIGHT
1/2"
8-070-01
8-155
3/4"
8-157¤
8-156¤
8-150-01¤
15-010¤
(Aftermarket).
1050.
R
a WICOR Company
SHURflo East
SHURflo Ltd.
52748 Park Six Court
Unit 5 Sterling Park
Elkhart, IN 46514-5427
Gatwick Road, Crawley
((800) 762-8094
West Sussex, RH10 2QT
(219) 262-0478
United Kingdom
FAX (219) 264-2169
+44 1293 424000
© 1998 Printed in USA
FAX +44 1293 421880
8-034
8-154
Advertisement
