Advertisement
OPERATING INSTRUCTIONS
Unpacking
Carefully unpack your infl ator. Dispose of all packing
material in an environmentally responsible manner.
Assembly
Your infl ator requires minor assembly before initial operation.
Check that you have all required components required for
assembly and initial use.
Rubber Stopper
To attach the rubber stopper to the bracket located on the
bottom of the tank;
1. Undo the nut and remove the washer.
2. Push through the bracket and replace the washer.
3. Tighten the nut, Pic. 2
Air Filter
The supplied air fi lter must be used.
Failure to do so may result in irreparable damage and will
void the warranty, Pic. 3
To install;
1. Carefully screw supplied air fi lter into the threaded hole
on the top of the pump head. This only needs to be done
up by hand. Do not use tools to tighten air fi lter.
NOTE: Do not OVER TIGHTEN as this may damage the air
fi lter or cylinder head which will NOT be covered under
warranty.
Once air fi lter is installed, fi t the quieting tube. The quieting
tube pushed into the small air fi lter inlet hole.
Wheels
1. Insert a bolt through the wheel.
2. Push through the tank wheel bracket.
3. Tighten the nut, Pic. 4.
WARNING
Do not attempt to operate this infl ator until it is fully
assembled.
Damage caused due to incomplete assembly will not
be covered under warranty.
Ensure the infl ator is disconnected from the power
supply before carrying out any assembly, maintenance
or adjustments on the machine.
PIC. 2
PIC. 3
PIC. 4
10
Hide quick links:
Advertisement
