Playing A Disc; Selecting A Desired Track/Passage - Toshiba CD328BT Instruction Manual

The display will show a flashing "READING", then the total number of tracks would be shown
and the playback will start from track.
5. To remove the CD, press
then press the PUSH TO OPEN button to open the CD compartment lid. Hold the CD by its
edges, and take it out carefully.
Note:
1. Make sure the disc is stopped before opening the CD DOOR.
2. To ensure good system performance; wait until the unit completely reads the disc before
proceeding.
3. If no disc loaded into the tray, or the disc is unreadable, the display will show "NO DISC".

PLAYING A DISC

1. The playback starts from track 1 automatically when reading the disc.
To pause playback, press
current playing time will flash on the display.
To resume playback, press
2. To stop playback, press
tracks will show on the display.

SELECTING A DESIRED TRACK/PASSAGE

To select a desired track
Press the /+10 or
control on stop mode or during playing until the desired track appears on the display. It will start
play automatically.
To search for a particular passage during playback (track scanning at high speed)
Press and hold the
control to scan the current playing track at high speed until desired point (passage) appears,
then release the button for normal playback mode. Playback will start again from this point.
To select a song which track number exceeds 10（for MP3 disc only）
To select a song/track which number exceeds 10, press and hold the
stop mode or press FOLD./10/M UP button on the remote control during playback each time to
skip forward 10 tracks in stop mode, then press the
remote control to select desired track.
To select a desired folder（for MP3 disc that contains more than one folder）
To select a desired folder during playback, press and hold the FOLD./10/M UP/DOWN button
on the remote control to next/previous folder.
PROGRAMING TRACKS
Programming tracks of disc are possible when playback is stopped. Up to 20 tracks for CD disc
and 99 tracks for MP3 disc can be stored in the memory in any order.
1． In stop mode, press the PROG./P-MODE button on unit or P-MODE key on remote to enter
program setting, the PROG logo will flash on the display and show P01.
2． Press the
/+10 button on unit or TUN+/
track to be programmed.
3． Press the PROG./P-MODE button on unit or P-MODE key on remote to enter. The display
would flash PROG and show P02.
4． Repeat steps 2 & 3 to store other desired tracks until all tracks programmed.
STOP button on unit or on remote control to turn off the unit,
/ PAIR button on unit or
/ PAIR button on unit or
STOP button on unit or on remote control, the total number of
/-10 button on unit or "TUN+/
/+10 or /-10 button on unit or TUN+/
(example: track 2)
key on remote control. The
key on remote control again.
"or "TUN-/
/+10 button on unit or TUN+/
on remote control to select the first desired
5
" key on remote
or TUN-/ key on remote
/+10 button on unit in
key on