Sony PWS-100TD1 Operation Manual page 23

4 inputs
Connect VTRs to the SDI 1 to 4 connectors. When SDI4 is
not used for ingesting, you can monitor the high-resolution
images of clips in the GUI.
VTR
REF
RAID configuration selection
After setting the system configuration, set the RAID configuration so that it has the same number SDI inputs and logical
drives as the selected system configuration.
You set the RAID configuration using the PWS-100 maintenance web application. Set up the RAID configuration shown
below, according to the selected system configuration. Configurations other than the following are not supported.
For details about configuration, refer to the operation manual of the PWS-100 maintenance web application.
• For 2 inputs/2 outputs: (5D + 1P) × 2
• For 3 inputs/1 output: (3D + 1P) × 3
• For 4 inputs: (2D + 1P) × 4
Note
If the RAID configuration is changed, all full-resolution files, proxy files, report files, and work orders written in internal storage are deleted.
Before changing the RAID configuration, always transfer or download all data to prevent data loss.
Operator Operator
HD/SD SDI
RS-422
HD/SD SDI
RS-422
HD/SD SDI
RS-422
HD/SD SDI
RS-422
Manager
Gigabit Ethernet
PWS-100TD1
USB 3.0
REF IN
USB 3.0
Drive unit
Sync signal
23
Overview