Table of Contents
Advertisement
Note:
(This note applies only to engines used in the U.S.A.) Maintenance, replacement or repair of the emission control devices and systems may be performed by any nonroad
engine repair establishment or individual. However, to obtain no charge repairs under the terms and provisions of the Briggs & Stratton warranty statement, any service or
emission control part repair or replacement must be performed by a factory authorized dealer.
How To Use Manual Figures
-
refer to figures inside covers.
19
1
-
refer to engine components in figure
Ê
Ò
-
refer to part/action in figures.
Record your engine Model, Type and Code numbers
here for future use.
Record your date of purchase here for future use.
In the state of California, OHV Model Series 120000
engines are certified by the California Air Resources
Board to meet emissions standards for 125 hours;
Model Series 200000 / 210000 for 250 hours. Such
certification does not grant the purchaser, owner or
operator of this engine any additional warranties with
respect to the performance or operational life of this
engine. This engine is warranted solely according to
the product and emissions warranties stated else
where in this manual.
Technical Information
POWER RATINGS: The power ratings for an individual
engine model are initially developed by starting with
SAE (Society of Automotive Engineers) code J1940
(Small Engine Power & Torque Rating Procedure) (Re
vision 2002 05). Given both the wide array of products
on which our engines are placed, and the variety of en
vironmental issues applicable to operating the equip
ment, it may be that the engine you have purchased will
not develop the rated horsepower when used in a piece
of power equipment (actual on site" power). This dif
ference is due to a variety of factors including, but not
limited to, the following: differences in altitude, temper
ature, barometric pressure, humidity, fuel, engine lu
brication, maximum governed engine speed, individual
engine to engine variability, design of the particular
piece of power equipment, the manner in which the en
gine is operated, engine run in to reduce friction and
clean out of combustion chambers, adjustments to the
valves and carburetor, and other factors. The power
ratings may also be adjusted based on comparisons to
other similar engines utilized in similar applications,
and will therefore not necessarily match the values de
rived using the foregoing codes.
Engine Components
IntekE Models
120000, 200000, 210000
1 Choke
.
2 Primer bulb
3 Push/Pull Safety key
4 Blower housing
5 Rewind starter handle
6 Fuel tank cap
7 Fuel tank
8 Fuel Shut off valve
9 Throttle lever
10 Oil fill/Dipstick (if equipped)
11 Electric starter (if equipped)
12 Oil drain plug
13 Engine Model
Type
xxxxxx xxxx xx
14 Muffler/Muffler guard
15 Spark plug*
16 Snow Hood
*Model 120000 Series spark plug is accessed by
removing snow hood.
Engine Components
Industrial PlusE Model
900000
1 Choke
2 Muffler
3 Carburetor
4 Low oil fill
5 Oil drain plug
6 Rewind starter handle
7 Spark plug
8 High oil fill / Dipstick
9 Electric starter
10 Engine Model
Type
xxxxxx
xxxx xxxxxxxxxx
Hazard Symbols and Meanings
Fire
Explosion
Kickback
Moving Parts
International Symbols and Meanings
(see fig.
)
Safety Alert
Safety Precautions
• Read entire Operating & Maintenance Instructions AND
• Failure to follow instructions could result in serious
Code
xxxxxxxx
* Briggs & Stratton does not necessarily know what
equipment this engine will power. For that reason, you
should carefully read and understand the operating
instructions for the equipment on which your engine is
placed.
THE OPERATING & MAINTENANCE INSTRUCTIONS
CONTAIN SAFETY INFORMATION TO
(see fig.
)
• Make you aware of hazards associated with engines
• Inform you of the risk of injury associated with those
• Tell you how to avoid or reduce the risk of injury.
information about hazards that can result in personal injury.
A signal word (DANGER, WARNING, or CAUTION) is used
with the alert symbol to indicate the likelihood and the potential
severity of injury. In addition, a hazard symbol may be used to
represent the type of hazard.
Code
Hot Surface
Toxic Fumes
The engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth defects, or other reproductive harm.
Shock
1
On Off
Stop
Read Owner's
Oil
Fuel
Manual
BEFORE OPERATING ENGINE
the instructions for the equipment this engine powers.*
injury or death.
hazards, and
The safety alert symbol is used to identify safety
DANGER indicates a hazard which, if not avoided,
will result in death or serious injury.
WARNING indicates a hazard which, if not avoided,
could result in death or serious injury.
CAUTION indicates a hazard which, if not avoided,
might result in minor or moderate injury.
,
CAUTION
when used without the alert symbol,
indicates a situation that could result in damage to
the engine.
WARNING
GB
Choke
Fuel Shutoff
Hide quick links:
Advertisement
Table of Contents
