Advertisement
Touch Screen Display
The generator can only display parameters and waveform of one channel at a time.
The picture below shows the interface when CH1 chooses AM modulation of sine
waveform. The information displayed may vary depending on the function selected.
The entire screen of the generator is a touch screen. You can use your figure or touch
pen to control the instrument. Most functions and selections can be chosen
using the touch screen in a similar manner to the front panel keys and knob.
7
1.Waveform Display Area
Shows the currently selected waveform of each channel. The key backlight
will turn on when this area of the touch screen is clicked.
2.Channel Status Bar
Indicates the selected status and output configuration of the channels. Touch this
area of the screen to switch to the corresponding channel. If touched again, the
shortcut menus for the function keys will be recalled: Mod, Sweep, Burst, Parameter,
Utility and Store/Recall.
3.Basic Waveform Parameters Area
Shows the current waveform's parameters of each channel. Touch this area of the
screen to highlight the parameter you want to configure, use number keys or knob to
change the parameter value.
2
1
6
3
4
Quick Start 11
5
Advertisement
