Extinguisher system
3
Extinguisher system
3.1
Communication Interface
The following table gives you an overview of the various states that your extinguisher system can be
in.
Key
Operation (green)
Battery operation
(yellow)
System tripped
(red)
System inactive
(yellow)
Extinguisher loss
(red)
Reset alarm (key
switch)
Flashing light
Acoustic signal
blinking LED
3.2
Operational status
Note!
This operating manual presupposes that the system has been installed by a licensed and
authorised installer or by the manufacturer. The installer will carry out the work within the
framework of the valid regulations and directives, and is liable for the quality of the
installation. This operating manual contains an Handover and Instruction Protocol (see
Chapter 8), which must be completely filled in by the installer and must be legally signed
by the operator. This protocol serves as a certification of the correct installation,
commissioning and handover of the extinguisher system to the operator.
The correct inspection of the extinguisher system in accordance with the Handover and
Instruction Protocol is the precondition for the safe and problem free operation of the
extinguisher system.
12
Building Technologies
Fire Safety
Operation
Battery
operation
Key removed
Key removed
illuminated LED
Incidents
System
System
tripped (fire
inactive
alarm)
Key
Key removed
removed
every 10 min.
constant.
for 6 sec.
every 10 min.
constant
for 6 sec.
LED off
Loss of
Reset alarm
extinguisher
after tripped
Key inserted in
horizontal
Key removed
position
(locked)
every 60 min.
for 8 sec.
every 60 min.
for 8 sec.
A54475-A1-A2_EN_05.docx
01.2018