SonicWALL TZ 150 Getting Started Manual page 27

Configuring Computers for Your Network with DHCP
If you enabled the DHCP Server in the Setup Wizard, each computer
on your network must be configured to obtain its IP address
dynamically. The following steps provide instruction on changing the
Local Area Connection settings for several versions of Windows.
Note: If you are not using DHCP, refer to the SonicOS Standard
Administrator's Guide.
Configuring DHCP IP Addressing
Complete the following section based on your operating system in order to
configure your management computer to obtain an IP address automatically
(using DHCP addressing):
Windows Vista
1. From the Start menu, right-click Network and select Properties.
2. In the Tasks menu, click Manage network connections, the
Network Connections windows displays.
3. Right-click on your Local Area Connection and select
Properties.
4. In the list, double-click Internet Protocol Version 4 (TCP/IP).
5. Select Obtain an IP address automatically and Obtain a DNS
address automatically.
6. Click OK, and then click OK again for the settings to take effect.
Windows XP
1. From the Start menu, highlight Connect To and then select
Show All Connections.
2. Right-click on your Local Area Connection and select
Properties.
3. In the list, double-click Internet Protocol (TCP/IP).
4. Select Obtain an IP address automatically and Obtain a DNS
address automatically.
5. Click OK, and then click OK again for the settings to take effect.
Page 26