Service And Maintenance During Break-In Period; Precautions You Should Take During The Break-In Period - Wolf Blaze User Manual

Precautions you should follow during the break-in period of a
new vehicle
1. Within the break-in period, replace the oil every 300 miles, and
clean the oil filter screen.
2. Regularly check for loose electrical connections, and tighten if
found.
3. Regularly check whether the engine, drive train and braking
system overheat, and whether there is enough lubricating oil on
each lubricated part. If any overheating occurs, the reason should
be found and rectified immediately.
4. Regularly check the tightness of the drive belt, the free travel of
the front and rear brakes, throttle grip and the handle bar
movement. Adjust them if necessary.
5. Within the break-in period, ride the vehicle only when the engine
is warmed up. First run it at low speed for 1~2 miles, and then
run it at higher speeds.
6. To reduce vibration and impact loads, the vehicle should run on a
level road with good road conditions whenever possible.
7. During the break-in period, carrying any unnecessary weight
should be avoided. Otherwise, the drive train will wear faster.
8. Try to avoid heavy braking and braking for long periods of time.
9. Strictly control the speed of the vehicle, varying the speed
regularly while riding.
27
USER'S MANUAL
Contents of Level 1 Service and Maintenance
Level 1 Service and Maintenance should be performed every
500~1000 miles. Its main contents are as follows:
1. Drain oil and refill to correct level with the correct weight
motorcycle oil. Standard 15W-40 or synthetic 5w-40.
2. Adjust the travel of the front brake handle to 10mm~20mm
(0.394-0.787 inch), and adjust the rear brake handle to
20mm~30mm (0.787-1.181 inch).
3. Adjust the travel of the throttle cable to 2mm~6mm (0.078-0.236
inch), and lubricate the throttle grip and the throttle cable.
4. Clean the carburetor, fuel tank, oil filter screen and air filter.
5. Adjust the idle speed of the carburetor.
6. Remove the carbon deposits on the spark plug, and adjust the
electrode gap of the spark plug to 0.025" or 0.6mm~0.7mm.
7. Remove the battery and charge it.
8. Check and tighten all bolts and nuts of all exposed parts.
9. Check the tightness of all connections of the electrical system.
10. Adjust the engine valve lash: intake valve to 0.03-0.05mm
(0.001-0.002 inch); and the exhaust valve to 0.05-0.07mm
(0.002-0.003 inch).
11. Store the vehicle in the best possible conditions.
Common Faults and Troubleshooting