Advertisement
Installation of the ABS M5 Kit | 4
Install the wheelspeed signal splitter D as shown on the picture in the front area on the
tunnel using velcrotape. This device duplicates the wheelspeed signal and provides it to
the ABS unit as well as to the display. There is no change to the display configuration re-
quired.
Illustration 19: Wheelspeed signal splitter with wiring loom plugged in
Install the bracket M for the fuses and the ABS diagnostic plug. The bracket is fitted at the
glove box area. You will find two fixation points for it as shown in the picture.
Left fuse: 10 A; middle fuse 25 A; right fuse 40 A.
In Gen 2 the fuse mounting uses the same fixation points as the fire extinguisher ECU
mounting. Dismount the ECU mounting and place the mounting plate behind the ECU
mounting.
Illustration 20: Bracket with fuses and hole for ABS diagnostic plug in Gen. 2
Remove the driver display. Fit the ABS warning light (MIL) above the display. The wiring
loom is designed to fit the MIL at this location. Only put the display back after the full wir-
ing loom installation has been completed.
Install the ABS 12-position switch (plus the corresponding sticker) and the ABS On/Off
switch in the center console. The required holes are indicated on the back of the console.
Illustration 21: ABS MIL
Bosch Motorsport
ABS_M5_Kit_Porsche_991_Cup_Installation_Instruction
13 / 16
Hide quick links:
Advertisement
