Bosch ABS M5 Kit Porsche 991 Cup Installation Manual page 12

4 | Installation of the ABS M5 Kit
12 / 16
Illustration 16: Connection to the inside wiring loom
Illustration 17: Arrow shows the Ground point
Installation of the inside wiring loom
At first the parts of the ABS Kit for inside the car shall be installed.
Install the yaw rate sensor F. Remove the screws from the loom fastener next to the driver
seat on the center tunnel. Leave the fastener at its original place. Place the mounting plate
E for the yaw rate sensor on top of the fastener. Use a file to slightly increase the width of
the oval holes in the mounting plate E. Screw the yaw rate sensor F onto the mounting
plate.
Illustration 18: Yaw rate sensor F on mounting plate E. Mounting plate on loom fastener
Attention: This picture is outdated and will be renewed soon.
ABS_M5_Kit_Porsche_991_Cup_Installation_Instruction Bosch Motorsport