Nordmende WDI860WH User Manual page 11

INSTALLATION
Levelling the washer dryer
！
Warning!
• The lock nuts on all 4 feet must be screwed tightly against the
housing.
1. Check if the legs are closely attached to the cabinet. If not, please
turn them to their original positions by tightening the nuts.
2. Loosen the lock nut by turning the feet until it closely contacts with
the floor.
3. Adjust the legs and lock them with a spanner, make sure the
machine is steady.
Connect Water Supply Hose
！
Warning!
• To prevent leakage or water damage, follow the instructions in
this chapter.
• Do not kink, crush, modify or sever the water inlet hose.
• For models equipped with a hot valve, connect it to the hot
water tap with the hot water supply hose. Energy consumption
will decrease automatically for some programmes.
Connect the inlet pipe as indicated, between an ordinary tap and the inlet hose.
clamp nut
Loosen the clamp
nut and four
bolts
1
Raise
1
Tighten the clamp
nut
2
Lower
2
slide bushing
Press slide
bushing, insert
inlet hose into
connecting
base
9 10
3
Lock nut
foot
3
Connection finished
4
4