Setup The Ip Address Of The Pc - Denon AVR-5805CI Operating Manual

The Operating Manual for DENON AV Receiver/Amplifier firmware upgrade

6. Setup the IP address of the PC.

1) Click [Start] on the taskbar of Windows, and open the Explorer.
2) Click [Control panel].
3) Click [Network Connections].
4) Double-click [Local Area Connections].
5) Press the property button on General tab of [Local Area Connections Properties]
6) Double-click [Internet Protocol (TCP/IP)] on [Local Area Connections Properties].
7) Check the status of General tab of [Internet Protocol (TCP/IP) Properties]
Please confirm the current setting of the Internet protocol
>Obtain an IP address automatically.
>Use following IP address.
After the upgrade, Internet Protocol address of PC is returned to former state.
Please write down this setting.
IP address and etc. are especially important when set to [Use following IP address].
8) Select [Use following IP address].
9) Set IP address: 192.168. 0. 2
10) Set Subnet Mask: 255.255.255. 0
11) Press OK button and finish.
After the upgrade ends, please return the setting by above mentioned similar operation.
Page 18 / 18