Two-seater High-back Reclining Sofa
One-seater High-back Reclining Sofa
Please make sure you read this before assembly
* Assembly requires at least two persons.
Cautions
* A screwdriver is not included, so please use your own Phillips head
screwdriver.
Parts List
2S 1S
2S: 2-seater/1S: 1-seater
2S
1S
Body
Spanner
2S
1S
Wooden legs
Felt sticker
* Note 1
Hexagonal bolts
Lever
* Note 1
* Note 1
Spring washers
Phillips screws
* Note 1
Parts
,
and
are assembled in
body
in advance. Before assembling, please remove
them using
spanner and your own Phillips
head screwdriver.
Completed assembly
Precautions for use
If the sofa is set and used in the same
Two-seater
beneath the sofa's legs may become
dented or damaged.
Always place the sofa on top of a carpet or
mat, etc.
One-seater
Maintenance inspections
Periodically inspect and tighten
screws.
* Please use properly after checking the enclosed Precautions for use .
Instructions for assembly and use
Assembly of body and wooden legs
* The assembly illustration shows the two-seater model, but
the same assembly also applies for the one-seater.
Remove
2S 1S
Felt
Turn
body upside-down, loosen
hexagonal bolts and
spring washers with
spanner, and remove these from
body.
Align the front and back of
wooden legs as
per the illustration on the right.
Lightly screw
hexagonal bolts and
spring
washers into all four of the screw holes in
body through the screw holes of the wooden
How to recline back/headrest
Back angle adjustment
When lowering the back:
Lower the back with the lever lifted and set the
angle by releasing the lever at your preferred
angle.
When raising the back:
The back will be raised
when the lever is lifted.
Retain this for future reference
Please lay down a carpet or rug
before assembly work in order to
prevent damage.
Cautions
* Use your own Phillips head
screwdriver.
* The lever can be installed on
the left or the right.
Lever
Thank you for purchasing this product.
Please read this sheet before assembly and use.
Please keep this sheet in a safe place for future
reference.
Lever installation
Lever
Step 1
Step 2
concealment
Remove
Remove the hook and loop
body is visible, and remove
fastener for lever concealment
screws using your own screwdriver.
on the left/right of body.
Step 3
Step 4
Once again close the lever concealment,
attach the hook and loop fastener to the
Headrest angle adjustment
The headrest can be adjusted manually to 6
Match with the back reclining angle to reach
your preferred angle.
In this position,
the gear lock
will be released.
Lever
concealment
Hook and loop
Lever concealment
Phillips
Lock
20110706
Need help?
Do you have a question about the Two-seater High-back Reclining Sofa and is the answer not in the manual?