Table of Contents
Advertisement
Chapter 4: Customising the System
Chapter 4: Customising the System
4.1 User setup
133_3c04.p65
The ST6000 Plus provides setup and configuration options that are
used to adjust the settings for the ST6000 Plus itself, the compass, and
the autopilot.
Note: You should perform the post installation procedures described
in Chapter 6 before adjusting any other calibration features.
There are three setup levels:
• User Setup, which controls compass setup, rudder calibration and
the ST6000 Plus display features
• Intermediate Setup, which displays version number information
• Dealer Setup, which controls the autopilot settings, and also the
calibration lock which can be used to prevent accidental access to
User and Intermediate Setup
The Dealer Setup options described in this chapter only apply if you
have installed the ST6000 Plus as the control unit for a Type 100/300
course computer. If you have installed the ST6000 Plus as a repeater
unit on an autopilot system, please refer to the Dealer Setup instructions
in the handbook for the main control unit.
Note: If the vessel type is changed, you must then relinearise the
fluxgate compass.
If an ST4000/5000 control unit is used, please refer to the
appropriate manual for system calibration.
The flow chart on the following page shows the User Setup control
procedure, and the setup screens with their default settings. Information
on the functions of the different settings is given in the remainder of this
section.
The following points should be considered:
• Make sure that the autopilot is in Standby mode before you access
User Setup
• If the CAL LOCK screen is displayed instead of the initial page, you
need to turn off the lock feature in Dealer Setup
• Setup options are always saved on exit
29
29
14/06/99, 10:23
Advertisement
Table of Contents
