Alarm Time Setting; Dimmer Control; Radio Operation; Wake To Radio - Salora CR 615 Instruction Manual

period of time. It is important that the mains supply is restored as soon as possible.

ALARM TIME SETTING

1. Press the Alarm Set Button (6) and simultaneously press the Hour Set Button (10) or Minute
Set Button (9) as appropriate until the required alarm time is reached.
2. To double check the alarm time, simply press the Alarm Set Button (6) then the display will
show the pre-set alarm time.

DIMMER CONTROL

Switch the Dimmer Selector (12) to High or Low position as required.

RADIO OPERATION

For AM reception, this unit uses an internal directional aerial, rotate the unit for best reception.
For FM reception, the wire FM Antenna (13) on the back of the unit should be fully unwound.
1. Set the Function Selector (11) to the "ON" position.
2. Set the Band Selector (4) to the required waveband.
3. Use the Tuning Control (3) to select the desired station.
4. Adjust the Volume Control (2) to the desired listening level.
5. To turn off the radio, set the Function Selector (11) to "OFF". If the radio does not switch off
this may be caused by inadvertent operation of the Sleep Set Button (8). To cancel this, press
the Snooze Button (5) once.

WAKE TO RADIO

Having selected your desired station and adjusted the desired listening level, proceed as follows:
1. Follow the instructions for "ALARM TIME SETTING" above.
2. When the desired alarm time has been selected, set the Function Selector (11) to the "AUTO"
position.
3. The radio will switch on automatically at the pre-set alarm time.
4. The alarm can be temporarily stopped for 9 minutes by pressing the Snooze Button (5) once.
5. Depress the Alarm Set Button (6) to turn off the radio. The alarm will activate again after 24
hours unless the Function Selector (11) is set to "OFF".

WAKE TO BUZZER

1. Follow the instructions for "ALARM TIME SETTING" above.
2. When the desired alarm time has been selected, set the Function Selector (11) to the
"ALARM" position.
3. The alarm tone will switch on automatically at the pre-set alarm time.
4. The alarm can be temporarily stopped for 9 minutes by pressing the Snooze Button (5) once.
5. Depress the Alarm Set Button (6) to turn off the buzzer. The alarm will activate again after 24
hours unless the Function Selector (11) is set to "OFF".
EN
2