Installation; Wire Color Table Of The Reader - IDTECK Star SR10 User Manual

PROXIMITY READER

6. Installation

6-1. Mullion/Wall Mount
Drill two 6-32 or M3 holes 3.3"(8.38cm) apart in vertical and drill one 1/2" hole for
the reader cable 1.7"(4.31cm) apart from the top hole.
(If you have installed electric gang box then skip this step.)
6-2. Put reader cable into the center hole and install the reader module by using two
6-32 or M3 screws.
6-3. Put bezel into the reader module then push bezel until you hear the locking sound.
7. Wire Color Table of the SR10/20
POWER
Power (DC +7V ~ +17V)
Power (Ground)
INPUT
LED Control
Buzzer Control
Output Format Selection 34 bit / 26 bit select
OUTPUT (Wiegand Format)
Wiegand Data-0
Wiegand Data-1
OUTPUT (RS232 Format)
RS232C
IDTECK
DC(+)
GND
LED_CON
Buzzer_CON
34/26_SLCT
Data-0
Data-1
TX
-5-
Red wire
Black wire
Yellow wire
Blue wire
Gray wire
Green wire
White wire
Violet wire
20031125