Important Safety Instructions; Product Introduction - IDTECK Star SR10 User Manual

PROXIMITY READER

1. Important Safety Instructions

When using STAR SR10/SR20 Philips Mifare™ Compatible Proximity Reader, basic safety precautions
should always be followed to reduce the risk of fire, electrical shock, and injury to persons. In addition, the
following should also be followed:
1. Read and understand all instructions of the User's Manual.
2. Follow all warnings and instructions marked on the product.
3. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
If necessary, use mild soap.
4. Do not use this product near water, such as bath-tub, wash bowl,
kitchen sink, laundry tub, in a wet basement, or swimming pool.
5. This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of power
supplied to your installation site, consult your dealer or local power
company.
6. Never push objects of any kind into this product or through the cabinet
slots as they may touch voltage points or short out parts that could
result in fire or electric shock. Never spill liquid of any kind on the
product.
7. To reduce the risk of electric shock, do not disassemble this product by
yourself, but take it to qualified service whenever service or repair is
required.
8. Unplug this product from the Direct Current (DC) power source and
refer to qualified service personnel under these conditions:
When the power supply cord or plug is damaged or frayed.
If liquid has been spilled on the product.
If the product does not operate normally after following the operating instructions in this manual.
If the product exhibits a distinct change in performance.
9. Do not use this product under dusty or vibration circumstance.

2. Product Introduction

The STAR SR10/ SR20 Philips Mifare™ Compatible Proximity Reader is an elegant looking 4" (10cm) read
range proximity reader which can be mounted to any flat wall surface. The SR10/SR20 Philips Mifare™
Compatible Reader reads serial numbers from Philips Mifare™ Compatible cards and transmits the data to
control panel in various output formats. The SR10/ SR20 uses the same epoxy-potted electronics module that
ensures you successful operation even in harsh environments. The two-color LED of green and red and the
piezo buzzer inside the reader will guarantee you accurate and reliable system operations.
IDTECK -3- 20031125